The following is a list of the class d amplifiers (which cost less than $500). This list is regularly updated with the current market leaders’ models. Our editors choose everything in our database and keep it up to date on a regular basis.
This page provides a list of the top 15 class d amplifiers that will undoubtedly assist you in finding your ideal match. Let’s begin with evaluations right now, without spending much time!
If you’re looking for a basic class d amplifiers, this top list is your best bet. It has an average rating of 4 stars after over 1200+ customer reviews and is one of our most popular items lately!
If you’re searching for a class d amplifiers, this list is the place to go. We’ve compiled a list of 15 of our favorites so you can make an informed decision. If anything specific comes to mind or you just want some advice, keep reading below:
Top 15 List of class d amplifiers is given below
We’ve consulted with renowned professionals who have in-and-out expertise about the class d amplifiers. We picked a product with uncommon features that you haven’t heard of before so that your purchasing experience would be interesting! Our team went through more than 100 options to make this list just right for you.
- Excellent for voice as well as bass
- 2 ohms. Freq.: 35Hz ~55Hz
- 8000 watts
- Mono
- Bass boost
- Class D MOSFET Monoblock Power Amplifier
- Peak Power at 1 Ohm: 1,600 Watts | RMS Power at 1 Ohm: 1,200 Watts
- Frequency Response: 20Hz - 250Hz, On-board Bass EQ Switch with +6 or +12dB boost at 45Hz
- Featuring 4-Way Protection Circuitry and 4 Gauge Power & Ground Input Terminals for Maximum Current Flow. Damping Factor - 150<
- Stable at 1 ohm | Remote Subwoofer Level Control Included
- Power - 3000 Watts Max x 1 @1-Ohm, 1500 Watts Max x 1 @2-Ohms
- Class D - Power loss is significantly reduced making the amplifier highly efficient. Excess energy is stored until it’s needed instead of being converted into heat. Reduction in size/weight, reduced power waste, smaller heat sink, compact circuitry
- 1 Ohm Stable - Able to continuously power loads of 1 Ohm without encountering difficulties such as overheating. Typically made to power up subwoofers that demand the heavier power load requirements to be able to perform the way they were made to
- Strapping Capable - You are able to strap TWO PL3000.1D amplifiers and double the power that is being sent to your subwoofer(s). You now have the ability to connect more subwoofers to take advantage of the extra power
- Variable Subsonic Filter - To prevent your subwoofer(s) from bottoming out, the variable subsonic filter filters out frequencies below the subwoofer(s) specified low frequency limits and allows the driver to reach a maximum safe excursion
- ❶ This AIYIMA A07 power amplifier adopt the TPA3255D2 amp chip and NE5532 op-amp chip.Very Quiet, Runs Extremely Cool,Easy to set up.It's a nice mini audio component amplifiers for Home Audio stereo system
- ❷ 300W+300W HiFi integrated class D amplifier, Exclusively designed for the customers who pursue HiFi sound,High efficient max power output up to 300 Watt
- ❸ Two input ways:3.5mm AUX Audio input/ RCA Audio input(3.5mm interface is also Aux Audio output interface(3.5mm AUX sed as audio output can go to connect any Powered device: Speakers, Amplifier,Active Subwoofer ect.).More detail connection and use ways,pls see the main picture shown)
- ❹ Simple compact design,And the exterior design is delicate and beautiful little amp,It can match with your computer/ desktop /Home theatre system and so on;A computer, an tube preamp(TUBE A3 PRO / T7 / T8), matched with our A07 home speaker amplifier, connected to your home audio passive speakers to form a perfect HIFI system, allowing you to liberate your ears in this noisy city
- ❺ Package with a DC 32V 5A Power Adapter for free,But if you want to get the maximum power of 300W, you need to buy a power adapter that uses DC 48V and current is above 7A(Cannot use industrial power supply,and please choose the correct passive speaker power to use ).
- The PRIME R1200-1D is an ultra-efficient mono amplifier (1.97" x 6.77" x 11.06") with top mounted controls and delivering 1,200 Watts RMS of power!
- Optimized exclusively for use with subwoofers (RMS Power Output: 400 Watts x 1 @ 4-Ohm OR 800 Watts x 1 @ 2-Ohm OR 1200 Watts x 1 @ 1-Ohm). Average Current Draw (13.8V Music)- 55 A. Max. Current Draw (13.8V Sinewave)- 110 A
- High efficiency, Class D design produces maximum power with minimal strain on the vehicle's electrical system while delivering rich, full bass to any system
- Delivering more bass where you want it most with On-board Punch EQ with +18dB boost @ 45Hz and fine tune the output from the driver’s seat with the included Remote Bass Level Control
- Featuring RCA pass-thru outputs, 12dB/octave Butterworth crossover, infrasonic filter, 4 gauge power/ground connectors, real time output and power supply thermal sensing, and MOSFET power supply
- 1 Ohm Stable Operation & Soft Turn On Circuit
- Thermal and Speaker Short Protection Circuitry
- Heavy-Duty Aluminum Alloy Heatsink | Class A-B Operation
- Remote Turn-On / Turn-Off Circuit
- LED Power and Protection Indicators
- Features: Monoblock Class D Amplifier. Power Handling: Maximum Output Power at 14.4V DC 1-Ohm: 3000W RMS | Maximum Output Power at 14.4V DC 2-Ohm: 2025W RMS | Maximum Output Power at 14.4V DC 4-Ohm: 1140W RMS. Input Sensitivity: 200MV, Signal-to-Noise Ratio: 86dB, Frequency Response: 10Hz-20kHz (-3dB).
- Crossover: High Pass Filter: 15 to 80Hz (-12dB/8) Variable | Low Pass Filter: 80Hz to Full (-12dB/8) Variable. Bass Boost: 0 to 12dB (50Hz), Thermal Management: Smart Cooler (Fan Powered by Temperature or Audio with 3 Speeds), Input Impedance: 56K-Ohms, Protection System: Output Short/High/Low Supply Voltage/Thermal Protection, Minimum Supply Voltage: 9V DC, Maximum Supply Voltage: 16V DC, Dimensions: TBA.
- Excellent for voice as well as bass
- 1 ohm
- 800 watts
- 4 channels
- Bass boost
- Colli-Menchi, Adrian Israel (Author)
- English (Publication Language)
- 256 Pages - 07/22/2016 (Publication Date) - Wspc (Publisher)
- CLASS D DESIGN WITH 800 WATTS OF POWER: Efficient Class-D amplifier with 1600 watts of peak power and 800 watts of RMS power
- ELIMINATES UNWANTED INTERFERENCE: 3-second turn-on/off delay to eliminate unwanted interference
- VARIABLE CROSSOVERS: Variable 12dB crossovers provide control to dial in the perfect sound
- KICKEQ BASS BOOST BUILT-IN: KickEQ 6dB variable bass boost for those additional low frequencies
- PROTECTION FROM DAMAGING FREQUENCIES: 24dB subsonic filter for protection from potentially damaging frequencies
- SKU: 44KXMA12002
- Brand: Kicker
- Competition Grade SPL Class D Monoblock MOSFET Car Power Amplifier
- Peak Power at 1 Ohm: 4, 700 Watts | RMS Power at 1 Ohm: 3, 500 Watts
- Stable at 1 Ohm, Frequency Response: 15Hz - 270Hz
- Featuring 4-Way Protection Circuitry and 1/0 Gauge Power And Ground Input Terminals for Maximum Current Flow
- User Adjustable Low Pass Filter (Variable): 35Hz - 250Hz, Remote Subwoofer Level Control Included
- 📢 PEAK POWER: 2200 Watts
- 📢 RMS POWER: 【4 ohms: 80W x 4 chan. + 350W x 1 chan.】 【2 ohms: 125W x 4 chan. + 600 x 1 chan.】 【4 ohms bridged: 250W x 2 chan.】
- 📢 BASS REMOTE: Variable Bass Boost 0 - +18 dB @ 45 Hz. Easily adjust with the included bass remote.
- 📢 MARINE CERTIFIED: Our VAD line includes a conformally coated, marine grade circuit board. This allows this amplifier to be installed in nearly any application.
- 📢 FEATURES: LED indicator lighting | 3-way protection circuitry | Heavy duty aluminum alloy heat-sink | Platinum-plated RCA level inputs | Platinum-plated screw terminals
- 300 Watts x 1 @ 4-Ohms, 500 Watts x 1 @ 2-Ohms, Frequency 20Hz to 250Hz +/-1dB
- Onboard 12dB/octave LP/HP/AP crossover & Infrasonic filter. Power Wire Gauge- 4 AWG. Power Input Connector-Screw Terminal. Suggested Alternator-75 A
- On-board Punch EQ with +18dB boost at 45Hz. Input Sensitivity: 150 mV to 4 V
- Cast Aluminum Heatsink with Stealth top mounted control panel
- Includes wired remote (Punch Level Control). High efficiency amplifier design that reduces current consumption from the charging system
Expert testers evaluate the goods. They’ve put them to the test in settings that are tailored to your exact demands. The reviews are public, so you may rest confident that they know what they’re talking about when it comes to choosing a new software solution!